Forestay Levers, Adjusters and Furlers

Fabricated from 316 stainless steel this well tested and reliable design is tough and strong. As well as being used for inner forestays they can also used as a safety device on boats fitted with furling headsails allowing a storm jib to be flown in an emergency. Essential for fast assembly of inner forestays in bad weather conditions.

There are 2 sizes in the range, for 6mm-8mm wire size. Manufactured in the UK by SeaSure.

Used on dinghies instead of a rigging screw for easy, pin-release adjustment. Made from Stainless Steel, supplied with clevis pins.

Made from Stainless Steel, supplied with clevis pins.

The Sea Sure jib furler is designed for complete reliability. The
drum is completely enclosed to prevent rope from coming off and
jamming during operation. It also features an all stainless steel
thrust bearing so that it still operates easily when the forestay is
fully tensioned. Being less than 50mm between centres allows the
jib to be set very low to the deck for maximum sail efficiency. It can
also be mounted below the deck using an additional stainless steel
extension tube. The furler will take up to 3.5m of 3mm line allowing
it to be used on sails with a foot length of approximately 3m (this is
reduced if larger diameter line is used). Drum Diameter: 69mm
Weight: 116g (25-54).

A robust lever made from 316 stainless steel with a 5 position adjuster. The long handle allows easy adjustment  even under considerable loads.